Maintenance; Cleaning The Bath; Drying The Pure Air ™ Ii Bath; Repairs To The Surface - Jacuzzi PURE AIR II Amiga Instructions D'installation Et De Fonctionnement

CLEANINg thE BAth

To clean your bath, simply use a mild, nonabrasive liquid
detergent solution. You can protect and restore the gloss to a
dulled acrylic surface by applying Meguiar's #10 Mirror Glaze,
a product specifically designed for use on acrylic finishes. If
Meguiar's is not available, an acrylic polish of equal quality or
automotive paste wax is acceptable.
Never use abrasive household cleaners on any Jacuzzi
Whirlpool Bath product.
DrYINg thE AIr BAth
The air bath motor will operate for twenty minutes and
then automatically shut off to end the bath, unless power is
manually removed by the Normal Mode switch. In either case,
twenty minutes after the motor has shut down, the blower will
turn on for a one-minute drying cycle to blow out any water
remaining in the air channel.
If the bath is used without the motor operating, the one-
minute drying cycle may be initiated manually by use of the
Normal Mode switch. Turn the switch on and off again as the
tub is being drained, and the drying cycle will occur in twenty
minutes.
Jacuzzi ® Comfort Pure Air II Bath: Installation and Operation
™

mAINtENANCE

rEPAIrS to thE SUrfACE

Major scratches and gouges that penetrate the acrylic
surface will require refinishing. Ask your Jacuzzi
Bath dealer for special instructions. Also see Clean-up After
Installation.

SKIrt PANEL rEmoVAL AND rEPLACEmENt

®
To remove the panel, take the top corner of the removable
access panel and pull it outward to release the first fastener.
Then work around the perimeter of the panel, pulling the panel
away from the remaining fasteners.
To replace, align the access panel in place so that the
fasteners on the panel match the fasteners on the tub, and
engage each pair of fasteners to secure the panel in place.
Page 1
Whirlpool
®
Removable
skirt panel
Top corner
of panel
Motor
Access
area
Remove
panel
BM62000D • February 2008