Drain Information; Plumbing; Water Supply; Clean-Up After Installation - Jacuzzi PURE AIR II Amiga Instructions D'installation Et De Fonctionnement

DrAIN INformAtIoN

A drain/overflow assembly (sold separately) must be installed
on the bath, water tested, and connected to the sanitary
system of the house. After opening the carton, inspect for
damage and verify that the kit is in the proper finish. Follow
the installation instructions provided with the drain/overflow
kit. After the drain is fully installed, test for proper drainage. If
the unit does not drain properly, rectify this condition before
proceeding with the installation. Jacuzzi
responsible for removal or reinstallation costs.
NotE: Watertight installation of the drain is the installer's
responsibility. Drain leakage is excluded from the warranty of
this product.

PLUmBINg

All Comfort Plus Series air baths are factory tested for proper
operation and watertight connections prior to shipping. If
leaks are detected, notify your dealer immediately. Do not
install the unit.

WAtEr SUPPLY

Consult local authorities for plumbing code requirements in
your area.
ImPortANt: Proper installation of the fill spout plumbing
and compliance with local codes are the responsibility of
the installer. Jacuzzi Whirlpool Bath does not warrant
®
connections of water supply fittings and piping, fill systems, or
drain/overflow systems. Nor is it responsible for damage to
the bath which occurs during installation.
CAUtIoN: A nonflammable protective barrier must be placed
between soldering work and bath unit to prevent damage to
the bath.
Jacuzzi ® Comfort Pure Air II Bath: Installation and Operation
™

CLEAN-UP AftEr INStALLAtIoN

The acrylic finish will give long-lasting beauty when properly
maintained. To avoid dulling and scratching of the finish,
never use abrasive cleaners or harsh chemicals. A mild liquid
detergent and warm water will clean soiled surfaces.
Remove spilled plaster with a wood or plastic edge. Metal
tools will scratch the surface. Spots left by plaster or grout can
be removed if lightly rubbed with a mild detergent and a damp
Whirlpool Bath is not
®
cloth or sponge.
Minor scratches that do not penetrate the color finish can
be removed by lightly sanding the surface with a 600-grit,
wet-dry sandpaper. To restore the glossy finish, use a special
compound like Meguiar's No. 10 Mirror Glaze. If it is not
available, use an automotive rubbing compound followed by
an application of automotive paste wax.
Major scratches and gouges that penetrate the acrylic surface
may require refinishing. Ask your Jacuzzi
dealer for special instructions or visit our web site at:
To find service agent listings for:
Page 1
http://www.jacuzzi.com/
Electrical or Mechanical Repairs, visit:
http://jacuzzi.com/pdf/ASA.PDF
Finish, Surface, or Shell-Related Repairs, visit:
http://jacuzzi.com/pdf/AFC.PDF
Repair Parts or Accessories, visit:
http://jacuzzi.com/pdf/MPD.PDF
Whirlpool Bath
®
BM62000D • February 2008