CAUtIoN: Test the ground fault circuit interrupter protecting this appliance periodically in accordance with manufacturer's
instructions.
WArNINg: Risk of hyperthermia and possible drowning: Water temperature in excess of 104°F (40°C) may be injurious to your
health. Check and adjust water temperature before use.
WArNINg: Prolonged immersion in hot water may induce hyperthermia. Hyperthermia occurs when the internal temperature of
the body reaches a level several degrees above the normal body temperature of 98.6°F. The symptoms of hyperthermia include an
increase in the internal temperature of the body, dizziness, lethargy, drowsiness and fainting. The effects of hyperthermia include:
a. Failure to perceive heat.
b. Failure to recognize the need to exit the spa or hot tub.
c. Unawareness of impending hazard.
d. Fetal damage in pregnant women.
e. Physical inability to exit the spa or hot tub.
f. Unconsciousness resulting in danger of drowning.
WArNINg: Risk of fetal injury: Pregnant or possibly pregnant women should consult a physician before using a hydromassage
bathtub equipped with a heater.
WArNINg: The use of alcohol, drugs or medication can greatly increase the risk of fatal hyperthermia. People using medications
or having an adverse medical history should consult a physician before using a hydromassage bathtub equipped with a heater.
WArNINg: Risk of hyperthermia and possible drowning: Do not use a hydromassage bathtub equipped with a heater immediately
following strenuous exercise.
WArNINg: Do not tamper with user-operated controls or such devices.
WArNINg: Use this unit only for its intended use as described in this manual. Do not use attachments not recommended by the
manufacturers.
WArNINg: To avoid injury, exercise caution when entering or exiting the hydromassage bathtub.
WArNINg: Risk of electrical shock: Do not permit electrical appliances such as a hair dryer, lamp, telephone, radio or television)
within 60" (1524 mm) of this hydromassage bath.
• Do not operate hydromassage system unless the bath is filled with water to at least 1 to 2" (25 to 51 mm) above highest jet.
• Do not immerse the control panel by overfilling the bath.
• Do not use oil-based bath additives in your hydromassage bath.
• When cleaning your bath, do not use abrasive substances which will damage the bath's surface.
• To prevent discoloration of the acrylic finish, do not fill the bath with water in excess of 140°F (60°C).
PRODUCT SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
The Company has obtained applicable code (standards) listings generally available on a national basis for products
of this type. It is the responsibility of the installer/owner to determine specific local code compliance prior to installation of the
product. The Company makes no representation or warranty regarding, and will not be responsible for any code compliance.
Jacuzzi
®
Comfort Pure Air
II Bath: Installation and Operation
™
oPErAtIoN
USE INSTALLATION INSTRUCTIONS SUPPLIED WITH PRODUCT.
Page
BM62000D • February 2008