In Case Of Difficulty; Maintenance - Jacuzzi DESIGNER Série Manuel D'installation

IN CASE OF DIFFICULTY

TUB
For the models with hydromassage, refer to the "Use and Main-
tenance" manual for the tub.
WARNING
Electronic safety cutout protection in operation
4"
The LED to the side of the hydromassage start button starts to
flash, and if you try to start the hydromassage, the disinfection
cycle or switch on the spotlight, these functions will not start.
The display, supplied with low voltage, is not disconnected.
To get the tub back into operaion you must press the hydro-
massage start button for about 4 seconds: the LED will stop
flashing, confirming that it has been re-started. If, however, elec-
tronic operation is still in operation, you must contact Jacuzzi
Service Center.
SHOWER AREA
I
No water is supplied from functions (shower, etc.)
Check that the mixer is open; for models equipped with ther-
i
mostatic mixer ( C), also check that the water stop tap is
open and that the filters are not blocked (see "Maintenance
- Dismantling and cleaning the thermostatic valve").
I
Little water is supplied from all functions
Check that the water supply system provides the pressure
values given in the installation manual.
For models with thermostatic mixer, check that the filters
are not blocked (see "Maintenance – Dismantling and clean-
ing the thermostatic valve").
I
Shower/ vertical hydro with inadequate pressure
Clean the filter situated between the showerhead and the
flexible showerhose.
Clean the nozzles (see "Maintenance" chapter).
For models with a thermostatic mixer, check that the filters
are not blocked (see "Maintenance – Dismantling and clean-
ing the thermostatic valve").
I
Difficult to adjust the water temperature (mixing)
Check that the pressure values for hot and cold are well-bal-
anced.

MAINTENANCE

TUB
I
The maintenance and cleaning of the tub is simple and rapid:
in fact, just use any neutral and non-abrasive liquid detergent.
Do not use abrasive cloths, powder detergents, acetone
or other solvents.
I
The tub can be periodically polished using an ordinary polish.
I
In the event of scratches or considerable damage, it is nec-
essary to contact specialized personnel.
I
For the models with hydromassage, refer to the "Use and
Maintenance" manual for the tub.
SHOWER AREA
I
The maintenance and cleaning of the fixture panel is simple
and rapid: in fact, just use any neutral and non-abrasive liquid
detergent.
Do not use abrasive cloths, powder detergents, acetone
or other solvents.
I
® To clean the glass panels, use specific products that can be
found at retailers.
I
If lime scale forms on the nozzles proceed as follows:
- turn the dial completely anti-clockwise, as far as it will go; then
pull it out.
- clean the dial, leave it covered in a liquid scale remover (do not
use metal tools). When putting it back into place, make sure
that it hooks onto the to the nozzle pins.
I
To avoid the formation of lime scale marks on taps and fittings,
just dry the various components after use. If it should be nec-
essary to clean them, simply remove any impurities with a soapy
wet cloth, rinse with clean water and dry.
For all maintenance and/or repair operations that re-
quire the replacement of components, original Jacuzzi
spare parts must be used. Failure to comply with this
regulation while carrying out this operation will mean
that the Manufacturer is not liable for any damage.
Jacuzzi Europe S.p.A. recommends that you contact your
local Jacuzzi ® Service Centre for all operations and in-
tervention not covered in this manual.
16
®