Disinfection - Pari Lamira Notice D'utilisation

• Rinse all nebuliser handset parts and
the front and back of the aerosol head
thoroughly under warm running tap
water to remove the dishwashing soap.
Check each part, and if soiling is still vis-
ible on any part of the nebuliser handset
or the aerosol head, place the part in
washing water for another 5 minutes.
NOTE:
Do not use any brushes or other tools to
clean the aerosol head. The possibility
of product components being damaged
cannot be ruled out.
• Shake all parts to remove most of the
water.

Disinfection

Disinfect the nebuliser handset and aero-
sol head immediately after cleaning them
(the nebuliser handset cannot be disin-
fected effectively unless it has been
cleaned beforehand).
NOTE:
Do not use a microwave to disinfect the
aerosol head. The possibility of product
components being damaged cannot be
ruled out.
Boiling in distilled water
NOTE:
Plastic may melt if it comes into contact
with the hot bottom of the saucepan.
Therefore, make sure there is enough
water in the pan. Otherwise, the parts may
be damaged.
44
• Place all parts in boiling water for at
least 5 minutes. Use a clean saucepan
and distilled water for this.
• Take the parts out of the saucepan.
• Shake all parts to remove most of the
water.
• Place the individual parts on a dry, clean
surface and allow them to dry
completely.
CAUTION:
Moisture promotes the growth of bacte-
ria. Please ensure adequate drying after
every disinfection.
Check the individual parts of the nebuliser
handset after every disinfection. Replace
all broken, misshapen or heavily
discoloured parts.
®
Lamira - 2020-08