Promax PROFI-70 Manuel D'utilisation page 62

Do not connect any cable other than that supplied by the manufacturer,
otherwise serious damage may be caused to the equipment.
1) Prior to connecting the equipment to a PC, disconnect both from their
respective power supplies.
2) Connect the end of the connection cable corresponding to the PROFI-70 to
connection [8] and the other end to the serial port of your computer or
portable serial printer.
Once the computer or portable serial printer has been connected, select on the
PROFI-70 the LOGGER operation mode. If PRINT function is selected data will be
dumped to the remote unit through the serial port.
The communication parameters used by the PROFI-70, and which therefore must
be defined on the remote unit (PC ) are the following:
Rate
Data bits
Parity
Stop bits
Page 24
USER'S MANUAL. PROFI-70
19200 bauds.
8 bits.
None.
1.
05/2008