Cleaning Instructions; Maintenance Instructions - L.B. White Premier TS040 Manuel Du Propriétaire Et Instructions D'installation

Cleaning Instructions

WARNING
Fire, Burn, and Explosion Hazard
components in the gas management, safety and
fail due to dust, dirt, wear, corrosive
environment, and aging.
proper maintenance are essential to avoid
serious injury or property damage.
1. Before cleaning, shut off all gas supply valves
and disconnect the electrical supply.
2. The heater should have dirt or dust removed
periodically:
a. Before each use give the heater a general
cleaning using compressed air or a soft brush
or dry rag on its case and internal
components. At this time, dust off the motor
case to prevent the motor from over-heating.
b. At least once a year, give the heater a
thorough cleaning. At this time, remove the
fan and motor assembly and brush or blow
off the fan blade assembly. Additionally, make
sure the burner air inlet venturi ports and the
casting are free of dust accumulation.
WARNING
Do not use a pressure washer, water, or liquid
cleaning solution on any gas controls. Use of a
pressure washer, water, or liquid cleaning
solution on the control components can cause
severe personal injury or property damage due
to water and/or liquids:
electrical shock or equipment failure.
from the leak.
Clean all components of the heater with
pressurized air, a dry brush, or a dry cloth.
Owner's Manual • Premier Ductable Heater
Premier Ductable Heater

Maintenance Instructions

BEFORE EACH USE:
clear and free of combustible
liquids.
connections for leaks or restrictions in gas lines.
vent is not blocked. Debris, insects, insect nests,
snow, or ice on a regulator can block vents and cause
excess pressure at the heater.
components within the heater for corrosion, frayed or
cut insulation, tight
connections, etc. Repair or replace as
necessary.
location, and when the heater is in use. If it is evident
there is excessive abrasion or wear, or if the hose is
cut, it must be replaced prior to the heater being put
back into operation.
diagram, warnings, start-up, shut-down,
troubleshooting, etc.) at the time of
maintenance for legibility. Make sure none are cut,
torn, or otherwise damaged. Any damaged markings
must be replaced immediately by contacting the L.B.
White Co., LLC. The data plate, startup and shutdown
instructions, and warning stickers are available as a
replacement part.
ANNUALLY:
necessary.
Have your gas supplier check the regulators
outlet pressure to make sure it is adjusted correctly.
proper operation. See Service Instructions in this
owner's manual.
17
-
-