L.B. White Premier TS040 Manuel Du Propriétaire Et Instructions D'installation page 14

14
Premier Ductable Heater
cap).
3. Slide the spring over the POL stem. The smaller di-
ameter end of the spring is toward the brass nut of the
POL. See Fig. 8. Slide the open side of the hand wheel
over the POL stem. Thread the assembly into the 1/4
in. inlet of the bushing installed in the regulator. Tighten
FIG. 8
Flats
Connecting the Regulator
to the Gas Supply
1. Insert the POL stem into the cylinder valve. Push the
spring loaded hand wheel up against the threaded nut.
Turn the hand wheel counter clockwise to thread the
POL nut into the propane cylinder valve. Firmly tighten.
See FIG. 9.
Cylinder
FIG. 9
Valve
POL Stem
gas valve inlet. See Fig. 10, Premier 40 shown.
Owner's Manual • Premier Ductable Heater
Spring (Smaller Diameter)
Hand
Wheel
FIG. 10
Gas Inlet Valve Hose Adapter
Hose Swivel Nut
3. Attach the hose's swivel nut to the hose adapter.
See. Fig. 10.
4. Slowly open the cylinder valve. This will prevent
stem. Check for leaks; correct if needed.
5. When storing or transporting the heater, use
protected from damage and water entry.
When using natural gas
as the fuel:
--- The regulator supplied with the dual fuel heater
is required for use with natural gas if the natural
gas supply pressure to the heater is above the
maximum inlet pressure of 13.5 in. W.C./3.36 kPa,
as stated on the heater's dataplate and in this
owner's manual.
--- The regulator requires a minimum natural gas sup-
ply pressure of 2 PSIG/13.8 kPa.
from the regulator inlet.
--- Connect the regulator to the natural gas supply
line using the proper connections.