L.B. White Premier TS040 Manuel Du Propriétaire Et Instructions D'installation page 7

Attention - Critical
Points to Remember!
service of propane gas and natural gas fueled
heaters, then do not attempt to light the heater,
perform service or repairs, or make any
adjustments to the heater on a propane gas or
natural gas fuel system.
and repair of radiant heaters, ALWAYS be
consciously aware of the odors of propane gas and
natural gas.
heater's joints; i.e. hose, connections, etc., is a
good safety practice under any conditions. If you
smell even a small amount of gas, CONTACT
YOUR FUEL GAS SUPPLIER IMMEDIATELY. DO
NOT WAIT!
1. Do not attempt to install, repair, or service this
heater or the gas supply line unless you have
continuing expert training and knowledge of gas
heaters.
QUALIFICATIONS FOR SERVICING AND
INSTALLATION:
experience to allow you to troubleshoot, replace
defective parts, and test heaters in order to get
them into a continuing safe and normal operation
condition. You must completely familiarize yourself
with each model heater by reading and complying
with the safety instructions, labels, owner's manual,
etc. that are provided with each heater.
all aspects of installing, repairing, and altering
gas lines, including selecting and installing the
proper equipment, and selecting proper pipe size
to be used. This must be done in accordance with
all local, state and national codes as well as the
manufacturer's requirements.
c. In the Commonwealth of Massachusettes, this
the Commonwealth of Massachusettes.
Owner's Manual • Premier Ductable Heater
Premier Ductable Heater
WARNING
ELECTRICAL GROUNDING
INSTRUCTIONS
This heater is equipped with a three prong
(grounding) inlet for your protection against electrical
shock hazard. It must be plugged into a properly
grounded three prong receptacle. Failure to use a
properly grounded receptacle can result in electrical
shock or death.
2. All installations or applications of L. B. White LLC
heaters shall meet the requirements of local, state
and national L.P. gas and natural gas, electrical
and safety codes. Your gas supplier, local licensed
agencies can help you determine these require-
ments. In the absence of local codes, comply with
the following:
a. Installations in the U.S.A.:
-- NFPA 102, standard for assembly seating, tents
and membrane structures
-- ANSI/NFPA 58, latest edition, Standard for Storage
-- ANSI Z223.1/NFPA 54, National Fuel Gas Code
-- ANSI/NFPA 70, National Electrical Code.
b. Installations in Canada:
-- CAN1-B149.1 or CAN1-B149.2 Installation Codes
-- CSA C22.1 Part 1 Standard Canadian Electrical
Code.
-- CSA C22.2 No.3, Electrical Features of Fuel
Burning Equipment.
3. We cannot anticipate every use which maybe
made of our heaters. Other standards govern the
use of fuel gases and heat producing products
advise you about these. Check with the local
applications.
4. Forced air heaters shall not be directed toward any
propane gas container within 20 feet/6.10 meters.
5. Do not wash the heater. Use only compressed air,
a soft brush or dry cloth to clean the interior of the
heater and it's components.
6. For safety, this heater is equipped with a manual
reset high limit switch, and an air pressure switch.
Never operate the heater with any safety device
that has been bypassed. Do not operate this heater
unless all of these features are fully functioning.
7