Manual Reset High Limit Switch; Fire Hazard - L.B. White Premier TS040 Manuel Du Propriétaire Et Instructions D'installation

20
Premier Ductable Heater
Manual Reset High Limit
Switch
WARNING

Fire Hazard

switch bypassed.
bypassed or jumper-ed may lead to overheating,
damage to the heater or property damage.
Premier 40 has one high limit switch; located directly below
the burner on the underside of the heat chamber.
Premier 80/170 has two limit switches, one inside the solid
door end on the heater chamber, the other inside the lou-
vered door end mounted on the fan housing side panel.
reset button in the center of the switch See FIG. 20 & 21,
Premier 170 shown.
FIG. 20
FIG. 21
Owner's Manual • Premier Ductable Heater
High Limit
High Limit
Function
If the heater overheats, the high limit switch can trip,
opening the electrcial circuit to the gas control valve.
Overheating is generally caused by duct restrictions,
low voltage, blocking the heater's air inlet, or excessive
gas pressure.
Resetting
If the high limit switch trips; remove the red cap and
Then, shut the heater off and turn it back on. Determine
the cause of the limit tripping.
Testing
To ensure proper function of this critcal safety
component, test the switch annually, typically when the
heater is given a thorough cleaning.
1. Remove the high limit switch from the heater.
2. With a pliers hold the switch by one of its mounting
portion on the back of the switch. See Fig. 22. Be
careful not to melt the plastic housing of the switch
when conducting this test.
3. Within a minute, you should hear a click coming from
the switch, indicating the contacts of the switch have
opened.
4. Allow the switch cool down for about a minute.
on the switch.
5. Check for electrical continuity across the switch ter-
minals to make sure the contacts have closed. Install
the red cap; reinstall back into the heater and connect
the wires to the terminals.
FIG. 22
Reset Button
Terminal
Mounting Leg
Sensing Surface
Flame