Locating The Ir Module; Connecting The Ir Module - Marmitek IR Control 10 Guide De L'utilisateur

5.4 Locating the IR Module

Mount the IR Module at an accessible place behind or alongside your A/V
equipment, in the vicinity of an electrical socket.
x
Be aware of the cable length of the IR LEDs and the IR receiver.
x
Make sure the connections for installation remain accessible.

5.5 Connecting the IR Module

1. Connect the installed IR extension cables to the 'IR OUT' connector of
the IR Module.
2. Switch only the switches of the IR Module in BLASTER mode if an IR
extension cable with one blaster LED is connected. In any other case,
leave
NOTE: a wrong choice between the two possibilities can cause
damage to the IR LEDs and they can even become defective.
3. Connect the installed IR receiver cable to the 'IR RCVR' connector of
the IR Module.
4. Connect the power adapter to the '12VDC' connector of the IR Module
and connect it to the mains.
5.6 Perform a function test of the product
1. If the IR Control 10/11 XTRA™ is properly connected, the light on the
IR receiver flashes if you push a button on the (infrared) remote control
and aim it towards the IR receiver.
2. Close the doors of your cabinet and make sure the A/V equipment
cannot receive an infrared command directly from the remote control.
Otherwise this could lead to operating problems.
3. You can now operate your A/V equipment via the IR Control 10/11
XTRA™ through the closed cabinet doors!
If the IR Control 10/11 XTRA is not reacting in a correct way, try
experimenting with the placement of the IR receiver and/or IR extension
cables (emitter or blaster). Placing it somewhere else could give a better
result.
8
the switch in the EMITTER
© MARMITEK
mode.