Marmitek IR Control 10 Guide De L'utilisateur page 9

6. ADVANCED INSTALLATION
6.1 Connecting multiple IR receivers
If you want to operate your A/V equipment from multiple rooms, you can
connect up to 6 IR receivers in parallel to the IR module. Cut therefore the
standard connector of the IR receiver and connect it to the SCREW
TERMINAL of the IR module (see paragraph 4.1).
6.2 Extend the cable length of the IR receiver
Only the cables between the IR receiver and the IR module can be
extended. The IR cables with emitter or blaster LEDs cannot be extended.
Place the IR module as close as possible to your A/V equipment and extend
the cable between the IR receiver and the IR module if needed to a
maximum of 300 meters with CAT5 cable (or equal). Cut the standard
3.5mm connector off the IR receiver cable and extend the cable according
to the example below.
IR receiver
Red
Black
Yellow
White
6.3 Connecting AVR connection cable
A/V equipment from different brands (for
instance Denon, Yamaha, Onkyo, Marantz,
etc) have a direct "IR IN" connector at the
back. A direct connection with the AVR
connection cables is an alternative way of
connecting your A/V equipment. The use of
an IR extension cable (with emitter or blaster LED) is not necessary here.
Note; check the technical documentation of your equipment to decide
whether the IR module of the IR control 10/11 XTRA can be connected
directly. Most IR cables use a 3.5mm mono jack connector where the tip is
used for the "IR Data" and the sleeve for "GND".
IR CONTROL 10/11 XTRA™
CAT5 cable IR module
Orange +12VDC
Blue GND
Green STATUS
Brown IR DATA
9