Marmitek IR Control 10 Guide De L'utilisateur page 7

Place the IR blaster LED in the cabinet of the A/V devices you want to
operate.
x
With a correct placement one
blaster LED can operate all
A/V devices placed in the
same compartment.
x
In some
necessary to place a second
blaster LED if not all A/V
devices can be operated with
one blaster LED.
x
Or you place the blaster LED
on one of the A/V devices in the middle of the cabinet and the other
equipment will be operated as well by the reflection of the infrared
signal.
5.3 Installation of the IR extension cable with emitter LEDs (as
problem solution)
Place the LEDs from the IR extender cable precisely on the IR window
(infrared sensor) on the A/V equipment that you wish to operate.
x
Ensure that the IR extender cable's LEDs are stuck precisely on the
A/V device's infrared sensor (this can be extremely accurate on some
devices). The exact position can easily be located by shining a torch on
the front panel and looking for the IR sensor window.
x
All IR LEDs include self-adhesive film with which they are attached to
your A/V equipment.
x
Test the position and the performance of the IR LEDs before you
secure them to the IR window on your A/V equipment.
x
If you use only one of the two LED's, leave the other IR LED unused.
Never remove it from the extension cable!
IR CONTROL 10/11 XTRA™
situations it is
7