How Does It Work - Marmitek IR Control 10 Guide De L'utilisateur

3. HOW DOES IT WORK?

Locate your A/V equipment in a closed cupboard, TV cabinet or even in
another room. The IR receiver must be installed in view of your own remote
control. Stick the IR blaster LED wherever you want in the cabinet and
conceals the IR main module neatly. Point the remote control at the IR
receiver in order to send the appropriate command to the IR LEDs (via the
IR main module). These will then immediately pass this onto the A/V
equipment.
The IR Control 10/11 XTRA™ is made up of three main components;
(1) IR Receiver
The IR Receiver receives infrared commands from your remote control and
sends these onto the IR Module.
The IR Control 10 XTRA™- contains an surface mount IR Receiver
The IR Control 11 XTRA™- contains a panel mount IR Receiver
(2) IR Module
The IR Module receives infrared commands from the IR Receiver,
processes them and sends them onto all connected IR Extender Cables.
(3) IR extension cable with two emitter LEDs or one blaster LED
The IR extension cable receives the infrared commands from the IR Module
and converts them via the IR LEDs or IR blasters into infrared signals. The
IR emitter LEDs have a limited range and therefore they have to be stuck
accurately on the IR receiver window of the A/V device you want to operate.
An IR blaster LED radiates much more infrared light (even up to 2 meters)
so it easily can operate multiple devices and therefore placing can be less
accurate.
4 © MARMITEK