Sime RS Mk.II Instructions Pour L'utilisateur page 67

the generator. If it is necessary to
move it to the left side, check that the
two rows of holes in the distributor
are directed upwards and toward the
front of the boiler (fig. 8).
KEY
1 Boiler body
2 M12 x 60 stud bolt
3 Seal ø 65/95 x 2
4 Distributor pipe
5 DN50 2" collar flange
6 Nut M12
2.9 ASSEMBLING THE BURNER
MANIFOLD
To assemble the burner manifold,
screw in the four TE M8 x 16 screws
on the threaded nibs of the two heads
of the boiler body (fig. 9).
KEY
1 Burner manifold
2 TE M8 x 16 screws
3 Right head
2. 1 0 ASSEMBLING THE BURNERS
Once the burner manifold has been
assembled, insert the burners in the
combustion chamber one at a time,
ensuring that the slits in the burner
are turned upward.
Push so that the burner support goes
KEY
1 Boiler body
2 Burner
3 Burner manifold
4 TCB M5 x 8
screw
5 Aluminium
washer ø 14
6 Burner nozzle
into the hole in the cast iron wall and
divides the elements (fig. 10). Anchor
the burner to the manifold with a TCB
M5 x 8 screw.
2. 1 1 ASSEMBLING THE SKIRT
Proceed as follows to assemble the
skirt (fig. 11):
Fig. 8
– Position the front and back supports
of the skirt base (1) between the
feet on the two heads.
– Anchor the side supports (2) and (3)
KEY
1 Front and rear skirt base support
2 Right skirt base support
Fig. 9
3 Left skirt base support
4 Lower left side rear panel
5 Upper right side rear panel
6 Front left side panel
7 Rear lower right side panel
8 Rear upper right side panel
NOTE: The position of rings (6) and (9) may be inverted, though the
ring with the slit must always be positioned on the side where the gas
assembly exits.
to the front and back of the skirt
base (1) with the M6 nuts supplied.
– Anchor panel (4) to panel (5) and
panel (7) to panel (8) using the con-
necting pins.
– and panels (7-8) to panel (9) using
connecting pins, anchoring them
together with two 7SP x 1/2" self-
tapping screws.
– Assemble panels (4) and (6) on the
base (3) , anchoring them on con-
necting pins. Proceed in the same
way to anchor panels (7) and (9) to
the base (2).
9 Front right side panel
10 Cover
11 Lower front wall
12 Upper front wall (cleaning plate)
13 Rear wall
14 Baseboard
15 Door
16 Upper front panel
Fig. 10
Fig. 11
63