How To Use Accessory Tray; How To Use The Adjustable Nozzle - Briggs & Stratton 020378-0 Manuel D'utilisation

3. ALWAYS point gun in a safe direction, press red button
and squeeze spray gun trigger to release retained high
water pressure.
IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• After each starting attempt, where engine fails to run, always
point spray gun in safe direction, press red button and squeeze
spray gun trigger to release high pressure.

How to Use Accessory Tray

The unit is equipped with an accessory tray with places to
store your spray gun and adjustable nozzle extension. There
is also a hook at the front of the accessory tray to hold your
high pressure hose.
NOTE: The extra hole in the tray is for storing a utility brush.
The extra clip in the tray is for storing a turbo nozzle. The
brush and turbo nozzle are NOT included with your pressure
washer. You can buy these items as optional accessories.
1. Place adjustable nozzle extension through hole on
accessory tray, as shown.
2. Place spray gun through hole on accessory tray on
right side of unit.
3. Hang high pressure hose on hook attached to
accessory tray on front of tray, as shown.
14

How to Use the Adjustable Nozzle

You should now know how to START and STOP your
pressure washer. The information in this section will tell you
how to adjust the spray pattern and to apply pressure
washer specific detergents.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER adjust spray pattern when spraying.
• NEVER put hands in front of nozzle to adjust spray pattern.
1. Slide nozzle backward (A) to achieve high pressure.
Slide nozzle forward (B) when you wish to adjust spray
to low pressure mode.
A
2. Point nozzle down towards a firm surface and press
trigger to test pattern.
3. Twisting nozzle adjusts spray pattern from a fan pattern
(C) to a narrow pattern (D).
C
Usage Tips
• For most effective cleaning, keep spray nozzle from 8 to
24 inches (20 to 61 cm) away from cleaning surface.
• If you get spray nozzle too close, especially using high
pressure mode, you may damage surface being cleaned.
• DO NOT get closer than 6 inches (15 cm) when
cleaning tires.
B
D
BRIGGSandSTRATTON.COM