How To Use The Adjustable Nozzle - Briggs & Stratton 020288 Manuel D'utilisation

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983

How to Use the Adjustable Nozzle

You should now know how to START and STOP your
pressure washer.The information in this section will tell
you how to adjust the spray pattern and to apply detergent
or other cleaning chemicals.
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
• NEVER adjust spray pattern when spraying.
• NEVER put hands in front of nozzle to adjust spray pattern.
1. Slide nozzle forward when you wish to adjust spray to
low pressure mode (Figure 10). Slide nozzle backward
to achieve high pressure.
Figure 10 — Adjusting Nozzle for Pressure
Slide nozzle backward
for High Pressure Mode
2. Point nozzle down towards a firm surface and press
trigger to test pattern (Figure 11).
Figure 11 — Testing the Spray Pattern
CAUTION
Slide nozzle forward for low
pressure mode and
detergent application
www.mymowerparts.com
Section 4: Operation
3. Twisting nozzle adjusts spray pattern from a narrow
pattern to a fan pattern (Figure 12).
Figure 12 — Adjusting the Nozzle for Spray Pattern
Rotate nozzle
counterclockwise for fan
spray pattern
Usage Tips
• For most effective cleaning, keep spray nozzle from 8 to
24 inches away from cleaning surface.
• If you get spray nozzle too close, especially using high
pressure mode, you may damage surface being cleaned.
• DO NOT get closer than 6 inches when cleaning tires.
Applying Detergent with the
Adjustable Nozzle
IMPORTANT: Use detergents designed specifically
for pressure washers. Household detergents could
damage the pump.
CAUTION
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
To apply detergent, follow these steps:
1. Review use of adjustable nozzles.
2. Prepare detergent solution as required by job.
3. Place filter end of chemical injection hose into
detergent container.
CAUTION
Keep the chemical injection tube from coming in contact
with the hot muffler.
• When inserting the filter into a detergent solution bottle,
route the tube so as to keep it from inadvertently contacting
the hot muffler.
11
Rotate nozzle clockwise
for narrow spray pattern