How To Stop Your Pressure Washer; How To Use Accessory Tray; How To Use Project Pro® Nozzle System; Low Pressure - Briggs & Stratton ELITE 2500 MAX PSI Manuel D'utilisation

How to Stop Your Pressure Washer

1. Release spray gun trigger and let engine idle for two
minutes.
2. Move throttle to "SLOW"
position.
3. ALWAYS point gun in a safe direction and press red
button and squeeze spray gun trigger to release
retained high water pressure.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction, press red button
and squeeze spray gun trigger to release high pressure, every
time you stop engine.

How to Use Accessory Tray

The unit is equipped with an accessory tray with places to
store your spray gun, nozzle extension and Project Pro®
nozzles. There is also a detachable hose wrap at the back of
the accessory tray to hold your high pressure hose.
1. Place nozzle extension in clip on back of accessory
tray.
2. Place spray gun through hole on accessory tray on
right side of unit.
3. Insert multi–colored nozzles in spaces provided in
accessory tray.
4. Wrap high pressure hose on hose wrap, then attach
hose wrap to back of accessory tray.
5. Hook provided on back of accessory tray for safely
storing safety goggles.
14
position, then "STOP"
How to Use Project Pro® Nozzle System
The quick–connect on the nozzle extension allows you to
switch between four different Project Pro® system nozzles.
Project Pro® nozzles can be changed while pressure washer
is running once spray gun trigger lock is engaged. The Project
Pro® nozzles vary the pressure and spray pattern as shown.

High Pressure

General
Delicate
40° Yellow 15° Orange
1750 PSI 2200 PSI
2.3 GPM 2.2 GPM
Follow these instructions to change Project Pro® nozzles:
1. Pull back collar on quick–connect and pull current
Project Pro® nozzles off. Store Project Pro® nozzles in
holder provided on the accessory tray.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
• NEVER exchange nozzles without the trigger lock being
engaged on the spray gun.
• DO NOT twist nozzles while spraying.
2. Select desired Project Pro® nozzle:
• For delicate rinse (lower pressure and higher flow),
for gentle cleaning of cars/trucks, boats, RV's, patio
furniture, lawn equipment, etc., select yellow
Delicate Project Pro® nozzle.

Low Pressure

Black
Use to apply
detergent
Max
0° Red
2500 PSI
2.0 GPM
BRIGGSandSTRATTON.COM