Fcontrol Panel Description; F.1 Control Panel Description; F.2 Basic Controls - Zanussi ZXLIG Instructions D'installation

ENGLISH
F CONTROL PANEL DESCRIPTION
F.1 Control panel description
9
1 2
On/Off button
Access button for parameters setting
2
Drain/self-cleaning button
3
Display
4
Wash cycles button
5
Cold rinse button
6
Cold rinse indicator light
7
Start button
8
Status:
• yellow = warming up or refill salt;
• green = ready;
• blue = working;
• purple = cleaning;
• white = programming mode;
• red = alarm or malfunctioning.
Off indicator light
9
F.2 Basic Controls
Described below are all the single buttons and functions
available in the control panel model listed above. Some
functions are common to all models of the range, whereas
others are available only on some versions.
On/Off
Press this button for at least 2 seconds to switch the appliance
on. Press the same button twice to switch it off . When the
appliance is off, the button indicator light
4
display shows OFF.
Access button for parameters setting
Press this button for 3 seconds to activate the parameters
menu and set basic appliance parameters. Refer to Installation
manual for more detailed information.
16
3
8
is red and the
4 5
Drain / self-cleaning button
Press this button to drain the water in the tank and to start a
self-cleaning cycle.
Wash cycles button
Press this button to select the most suitable washing cycle.
4
The display shows you your selection.
Cold rinse button
Press this button for 3 seconds to activate this option, the
corresponding button indicator is lit up. A cold rinse cycle starts
at the end of the selected wash cycle. The start button
blue and the display shows that the cold rinse is running.
Particularly suitable for rinsing glasses.
Start button
Press this button to start the selected washing cycle or confirm
your selection during the parameters setting.
6 7 8
8
is