E.5 Disposal Of Packing; E.6 Plumbing Connections; E.7 Electrical Connections - Zanussi ZXLIG Instructions D'installation

ENGLISH
Arranging the machine:
• Wear protective gloves and unpack the machine.
• Lift the equipment with a lift truck, remove the base and
position it the place of use.
• Carefully remove the protective film from the outer panels
without tearing it, to avoid leaving traces of glue.
• Adjust the equipment by turning the special adjustable feet
and making sure it is perfectly level, both length wise and
crosswise.
4x
E.5 Disposal of packing
The packing must be disposed of in compliance with the
current regulations in the country where the appliance is used.
All the packing materials are environmentally friendly.
They can be safely kept, recycled or burned in an appropriate
waste incineration plant. Recyclable plastic parts are marked
as follows:
14
Polyethylene
• Outer wrapping
• Instructions bag
Polypropylene
• Straps
Polystyrene foam
• Corner protectors
The parts in wood and cardboard can be disposed of,
respecting the current regulations in the country where the
machine is used.
E.6 Plumbing connections
• Connect the appliance water supply pipe "WI" (see the
installation diagram) to the mains, fitting a cut-off tap, the
filter provided and a pressure gauge between the appliance
and the mains (see figure below).
• In models with incorporated water softener and in some
specific models, connect the double non-return valve "B"
supplied and the machine supply pipe (see figure below).
B
• Check that the dynamic water supply pressure, measured
between the appliance and the main, is between 1 bar [100
kPa] and 6 bar [600 kPa] (test while dishwasher tank or
boiler is filling with water).
NOTE!
If the pressure is too high, fit a suitable pressure
reducer on the inlet pipe.
– On the model with free-fall drainage:
connect the waste outlet pipe (detail "D" in the installation
diagram) to the main drain pipe, fitting a trap, or place the
outlet pipe over a trap set into the floor.
– On the model with drain pump:
position the outlet pipe at a height anywhere between
100 mm and 800 mm from the floor. Depending on the
model, check that from 2 L to 3 L of water flow out of the
outlet pipe during the rinse cycle.
IMPORTANT
Make sure drain pipe does not kink, pinch or
twist, resulting in a water flow restriction.
CAUTION
Always use a new set of joints if you
remove and reinstall the water inlet pipe to
the appliance.
IMPORTANT
Watermark labelled appliances must be installed in
accordance with AS/NZS 3500.1 and drainage to
be in accordance with 3500.2.
E.7 Electrical connections
• Connection to the power supply must be carried out in
compliance with the regulations and provisions in force in
the country of use.