Gcommissioning; G.1 Preliminary Checks, Adjustments And Operational Tests; Hbasic Setup; H.1 First Activation - Zanussi ZXLIG Instructions D'installation

G COMMISSIONING
G.1 Preliminary checks, adjustments and
operational tests
WARNING
These operations must only be
carried out by specialized techni-
cians provided with adequate
personal protection equipment
(e. g. safety footwear, gloves,
glasses, etc.), tools and suitable
ancillary equipment with the
appliance switched off and cold.
Electrical and plumbing checks
Before starting the machine:
• check correct connection of the electrical wires that feed the
machine;
• make sure the power supply voltage and frequency match
the data given in the technical data table (C TECHNICAL
DATA);
• check correct connection of the water supply and drain
pipes (see paragraph E.6 Plumbing connections);
H BASIC SETUP
H.1 First activation
When the dishwasher is activated for the first time, it is
necessary to set several parameters to configure the user
interface. At the end of this operation, the dishwasher is ready
to work.
NOTE!
These parameters must be inserted again only
when the dishwasher has been restored to the
factory set up.
How to navigate in the parameters menu
On/Off button
Press this button for 2 seconds to turn on the
dishwasher.
Exit button
2
Press this button to come back to previous menu
parameters.
Up button
3
Press this button to move to the next parameter.
Down button
4
Press this button to move to the previous
parameter.
Edit/confirm button
5
Press this button to access "edit" mode or to
confirm the value.
Select the language
• At the first activation, the display shows to select the
language.
3 4
• Press button or to view all available languages.
5
• Press button to confirm the language.
• make sure all the guards, safety devices and emergency
switches are in place and efficient.
Check the positioning of tank components
• Make sure that, the overflow "1", the pump filter "2", the flat
tank filter "3" (depending of the model), the lower wash and
rinse arms "4" and the upper wash and rinse arms "5" are
correctly fitted (see picture below).
Confirm the electronic code
5
• Press button to confirm the value.
Water hardness selection
5
• Press button to access menu.
3 4
• Press button or to view all available values.
5
• Press button to confirm the value.
Activate preload dispensers
5
• Press button to confirm the choice.
3 4
• Press button or to move from value "OFF" to "ON".
5
• Press button to confirm the value.
• The display shows to insert the suction pipes into the
detergent and rinse aid tanks.
5
• The button blinks white waiting for the confirm of the
operation. Press again the same button to confirm it.
Activate preload detergent
5
• The button blinks white waiting for the confirm of the
operation. Press again the same button to confirm it.
Activate preload rinse aid
5
• The button blinks white waiting for the confirm of the
operation. Press again the same button to confirm it.
Main menu
2
• Press button to go back in the main menu.
Exit configuration mode
• Press button to exit configuration mode and turn off the
dishwasher.
ENGLISH
17