First Start-Up - GYS NEOCUT 105 Mode D'emploi

CUTTING MODE CHOICE
Cutting / cutting with locked trigger
Use one of these two modes to perform your cutting work on solid sheet metal.
Pull the trigger to create the arc, and release it to stop or «unlock» (the arc stops by itself).
For long cuts it is possible to use the locked trigger mode, in which case the trigger can be released during cutting. This mode
prevents fatigue and keeps your hand a little further away from the cutting area.
Gouging / gouging with locked trigger
Use one of these two modes to perform your gouging work.
Pull the trigger to create the arc, and release it to stop or «unlock» (the arc stops by itself).
For long cuts it is possible to use the locked trigger mode, in which case the trigger can be released during cutting. This mode
prevents fatigue and keeps your hand a little further away from the cutting area.
Cutting of perforated metal sheets
Use this mode to perform cutting work on perforated metal sheets that require repetitive cutting stops / restarts.
This is a cutting mode where the arc recharges itself as long as the trigger is held down. This mode is more comfortable to
use, as it avoids constant pull and release of the trigger.
Marking out
This mode, compatible with all cutting consumables, operates at low current and allows surface marking of sheet metal.
Particularly useful for automated cutting to record for example references, bundle numbers... this mode is also accessible with
a manual torch.
FIRST START UP
At first startup, the machine will ask you to configure the following parameters:
(EN) ENGLISH
(FR) FRANCAIS
(DE) DEUTSCH
1
(IT) ITALIANO
(ES) ESPANOL
(NL) NEDERLANDS
(RU) RUSSKIY
Language
3 MT/AT-125
MT/AT-160
Torch model
(NEOCUT 125 only)
Rotating the scroll wheel moves the cursor in front of the desired selection, pressing the scroll wheel validates the selection.
Note: In the event of an input error, these parameters can be changed (see Setup menu).
HMI NAVIGATION
SCROLL WHEEL USE
Turning the scroll wheel allows
- an adjustment of a digital parameter (current, pressure)
- moving the cursor to make a selection
Pressing the scroll wheel
- allows to confirm a selection (pointed by the cursor)
- access the toolbar from the main screen or from the pressure setting screen
24
NEOCUT 105 / 125
2 m. /bar
ft./psi
Units (m./bar or ft./psi)
6.0m/20ft
7.6m/25ft
4
12.0m/40ft
15.2m/50ft
Torch length
3-4 :
Important setting for the correct
operation of the product. This data is
used by the power source to calculate
and apply the optimum operating pres-
sure.
EN