GYS TIG 160 DC LIFT Mode D'emploi page 11

c. Protection and reinforcement: Selective shielding of other cables and equipment in the surrounding area may
allev iate problems of interference. Shielding of the entire welding area may be considered for special applications
d. Connect the earth directly to the metal workpiece: Where necessary, the connection of the workpiece to an
earth should be made direcltly, but in some countries where direct connection is not permitted, the earth
connection should be achieved by suitable capacitance, selected according to national regulations.
SAFETY
Arc welding can be dangerous and can cause serious and even fatal injuries.
Protect yourself and protect the others.
Ensure the following safety precautions are taken:
Arc rays: Protect yourself with a helmet fitted with filters in compliance with EN169 or EN379.
Ensure you inform and protect other people in the welding environment.
Rain, steam, Use your welding unit in a clean/dry environment (pollution factor ≤ 3), on a flat
surface, and more than one meter from the welding work-piece. Do not use in rain
Humidity
or snow.
This device must only be used with an earthed power supply. Do not touch the
Electric shocks:
High voltage parts. Check that the power supply is suitable for this unit.
Do not underestimate the weight of the apparatus. Do not move the unit over people or
Moving:
objects. Do not drop it. Do not set the unit down heavily.
Wear protective (fire-proof) clothing (cotton, overalls or jeans).
Burns:
Wear protective gloves and a fire-proof apron.
Ensure other people keep a safe distance from the work area and do not look
directly at the welding arc
Protect others by installing fire-proof protection walls
Remove all flammable products from the work area. Do not work in presence of
Fire risks:
flammable gases.
Do not inhale welding gases and fumes. Use the device in a well ventilated
Fumes:
environment, with artificial extraction if welding indoors.
Extra precautions:
-
-
-
must always be approved by a "responsible expert", and made in presence of
people trained to intervene in case of emergency.
Technical protection as described in the TECHNICAL SPECIFICATION "IEC 62081"
MUST BE taken.
Welding in raised positions is forbidden unless safety platforms are used.
People wearing Pacemakers are advised to see their doctor before using this device
Handle gas bottles with care - there is increased danger if the bottle or its valve are damaged.
Any welding operation undertaken in:
Environments with increased risk of electric shock,
Poorly ventillated rooms,
The presence of flammable or explosive materials
Do not use this device to unfreeze pipes.
11/20