GYS TIG 160 DC LIFT Mode D'emploi page 9

Masquer les pouces Voir aussi pour TIG 160 DC LIFT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TIG WELDING (TIG LIFT MODE)
The DC TIG welding requires a protective gas (argon).
Follow the steps below:
1. Connect the earth clamp to the positive socket (+).
2. Connect the torch to the negative socket (-), the DINSE connector and the gas connector.
3. Connect the gas pipe from the rear of the welder to the flowmeter of the gas cylinder
4. Select TIG mode
5. Adjust the desired current (display ) using the keys , according to the thickness of the metal
workpiece (30A / mm).
6. Set the gas flow on flowmeter.
7. To start :
a- Touch the electrode on the welding
workpiece
8. When finished:
Release the trigger, downslope, post-gas
Adjustment of downslope
Function activation:
Recommended combinations / Electrode grinding
Current (A)
0.5-5
10-130
4-7
130-190
To optimise the welding process, it is recommended to grind the electrode prior to welding as described in
the diagram below:
d
DIN connector – Torch command
using the selector button , press until the TIG indicator illuminates.
This function allows the user to adjust the time required at the end of
welding for the gradual decline in the welding current until the arc stops.
This function helps to avoid cracks and craters at end of welding. To activate
it, proceed as follows:
1- Press the selector button
2- The TIG indicator starts flashing and the display indicates the current
downslope time
3- Set the automatic arc downslope you wish from 0 to 10 sec (display )
using key .
4- Validate your choice pressing button
illuminated.
Ø Electrode (mm)
= Ø wire (filler metal)
1.6
2.4
L = 3 x d for a low current
L
L = d for a strong current
l
1
3
for 3 seconds
Ø Nozzle (mm)
9.8
11
2, 4 & 5 : not connected
b- Raise the electrode to
between 2 - 5 mm from the
workpiece.
. The TIG indicator remains
Flow rate (Argon L/mn)
6-7
7-8
9/20

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Tig 160

Table des Matières