Full Setup; Network Configuration; Default Configuration; Changing Network Parameters - Gorgy Timing LEDI NETWORK TOP Série Mode D'emploi

This part contains information for a full configuration of the product. It should be
used for fine network configuration and output set-up.

2.1. nEtwORk COnFIGURatIOn

2.1.1. Default configuration

The LEDI NETWORK TOP is configured to automatically take an IP address from a
DHCP server. At startup, the product broadcast a DHCP query to get an IP address.
This query contains a DHCP name. There are two cases:
► If a DHCP server is installed on the network, it record the DHCP name and return an
IP address. The LEDI NETWORK TOP starts working with this address.
► If no DHCP server is installed, the LEDI NETWORK TOP automatically uses a de-
fault IP address in the range 169.254.x.y (where x and y are between 0 and 255).
The default DHCP identifier of the product is ntnnnnnn with nnnnnn, the serial num-
ber on 6 digits. The serial number is written on the identification stamp on the top or on
the bottom of the product.
The default SNMP name of the product (that can be seen from a SNMP browser (see
part 5) or from a WEB browser) is Ledinettopnnnnnn with nnnnnn, the serial number
on 6 digits.

2.1.2. Changing network parameters

Use the GTNetMng tool provided on the CDROM to configure your device:
► Insert the CDROM in the drive. Start the GtnetMng tool that is localized in the
directory CDG020\English\Software-tools-Gorgy\Gt_network-Manager
For example, if your CD reader has letter E:, the GTNetMng tool is localized in E:\CDG020_021V01\English\
4
Software-tools-Gorgy\GT_Network-Manager\GTNetMng.exe
50
2.

FULL SEtUP

4
MDE-LEDInetworkTOP-4092-V1.1