Full Setup; Network Configuration; Default Configuration - Gorgy Timing LEDI Mode D'emploi

This part contains information for a full configuration of the product. It should be
used for fine network configuration and output cards set-up.

2.1. NETWORK CONfIGURaTION

2.1.1. Default configuration

The LEDI Network ITS/DCLS/NTP Server is configured to automatically take an IP
address from a DHCP server. At startup, the product broadcast a DHCP query to get
an IP address.
This query contains a DHCP name. There are two cases:
► If a DHCP server is installed on the network, it record the DHCP name and return
an IP address. The LEDI Network ITS/DCLS/NTP Server starts working with this
address.
► If no DHCP server is installed, the LEDI Network ITS/DCLS/NTP Server automati-
cally uses a default IP address in the range 169.254.x.y (where x and y are between
0 and 255).
The default SNMP name of the product (that can be seen from a SNMP or from a WEB
browser) is LediITSnnnnnn / LediDCLSnnnnnn with nnnnnn, the serial number on
6 digits.
MDE-LEDInetworkITS-server-4078V1.3
2.

fULL SETUP

79