Standard Setup; A/ Network Parameters - Gorgy Timing LEDI NETWORK TOP Série Mode D'emploi

4.2.2. Standard setup

When you click the Standard button, the network parameters and product informations
are displayed as shown below:
In the top of the panel, you can control the network parameters and the WEB access
password. In the bottom of the panel, you have information about the product.

a/ network parameters

Warning!
If you click on the Set Up! button after changing one or several
network parameter(s), the LEDI NETWORK TOP must restart to use
the network parameters. During the reset and 2 minutes after, the
output of the product is disabled.
Here are the different parameters:
► IP mode
Indicate if the LEDI NETWORK TOP works with a fixed IP (set in the field IP address)
or use DHCP protocol (the DHCP identifier is set in the field DHCP identifier).
MDE-LEDInetworkTOP-4092-V1.1 57