Gorgy Timing LEDI NETWORK TOP Série Mode D'emploi page 63

It shows the different servers used for synchronization and the current synchronization
mode (on the screenshot above, there is only one server at IP address 192.168.10.124).
In addition, this screen part shows what is the server currently used for synchronization
(with a frame labeled active). If a commutation is in progress, the label trying is dis-
played nears the related NTP server.
The left part of the NTP screen allows you to configure the synchronization mode and
the NTP servers used:
If you select the checkbox auto-detection, the LEDI NETWORK TOP try to use the GT
NTP servers present on your network and use the more appropriate synchronization
mode. If you don't select the checkbox auto-detection, you have to indicate the syn-
chronization mode and the NTP servers to use.
the following table can help you to select the more appropriate parameters:
Mode # of NTP servers used
One server
Two servers
Three servers
MDE-LEDInetworkTOP-4092-V1.1
1 Use only one server for synchronization
Use the first server at startup. If this server fails,
2 commute to the second server. If this server
fails, commute to the first one and so on...
Use the first server at startup. If this server fails,
3 commute to the second server. If this server
fails, commute to the third one and so on...
Description
63