Particular Instructions For Use - Tractel PalTurn Notice D'utilisation

PARTICULAR INSTRUCTIONS FOR USE

Applications requiring 2 loads turners in a synchronized use
▪ Install each device on a hoisting means adapted to the load.
▪ During the connection of the load turners to the electrical installation, check that the rotation is in the
same sense for each device.
▪ During the positioning, check that the devices are oriented so as to insure a rotation in the same sense.
▪ The devices must lift the load at the same time so as to maintain the load horizontally during the lifting
including – before, during and after the turnover – and during the load setting down.
▪ During the positioning of the devices, check that the load is uniformly distributed on the 2 devices: the
devices must be spaced equidistantly from the center of gravity axle of the load.
▪ If the above criteria cannot be respected during the application, the WLL of the devices must take into
account the load offset of one of the devices.
F1
Distance between Pal-Turn
FRONT
SIDE
N°1
Strap
FRONT
SIDE
M 6067 M
rev 11 – 02/2022
GB
TM
is free, it is adjusted with
lifting devices
Load CoG axis
F = Total Weight
Important verification:
•
F1 = D2*F /(D1+D2)<WLL PalTurn™ N°1
•
F2 = D1*F /(D1+D2)<WLL PalTurn™ N°2
F1
N°1
Load CoG axis
F2
FRONT
SIDE
N°2
F2
N°2
FRONT
SIDE
F = Total weight
Page 21/92
www.tractel.com