Building In - Atag HI7071A Livret D'instructions

installation
possibilities for building in
attention
Ensure that the connection cables hang freely. If there
is a drawer underneath the hob, make sure that the
contents do not project above the edge of the drawer
and interfere with the ventilation.
installation of the induction hob above a combi-
microwave oven, a 90 cm ATAG oven or an oven of a
different brand
2
e
50 cm
e
t
e
r
r
t
e r
t
min.
560 x 6 mm
52
50
200
GB 30
Saw out the ventilation opening(s), making sure
that the total surface of the holes is a minimum
of 100 cm 2 . See the drawing, for example,
showing 2 holes of 50 cm .
2
Fit a protective plate between the oven and the
hob. The plate should be at least 10 mm thick
and heat-resistant (85 °C). The space between
the underside of the hob and the protective plate
must be at least 50 mm.
To protect the air flow, fit a protective panel - of
the same material as the protective plate -
between the protective plate and the hob.
Ventilation is via the adjoining cupboards.
fitting the connection cable
1.
Open the cover of the junction box with a
screwdriver.
2.
Fit the connection cable and make the correct
connections using the bridges supplied (see wiring
diagram). Inside the lid of the connector block, you
will find an illustration showing how to make the
connections with the bridges.
3. Fasten the cable with the strain relief and close the
cover.
If you wish to make a fixed connection, the plug
should be fitted with a multipolar isolating switch with
a minimum contact gap of 3 mm.
Hob type Induction
Component voltage 230V 50Hz
Appliance width x depth 770 x 510 mm
Built-in height from
top of worktop 48 mm
Cut-out width x depth 750 x 490 mm
Worktop thickness 28 – 50 mm
Capacities of modules
Left 3600 W
Right 3600 W
Use an approved cable for the connection, in
accordance with the regulations. The cable casing
should be of rubber.
installation

building in

inside the appliance
right zones
left zones
1 2 3 4 5
GB 31