Atag HI7071A Livret D'instructions page 62

operation
switching on
boost
In setting '
left cooking zone) has a maximum capacity of 2800 W. Use
this setting if you want to bring dishes to the boil quickly.
Powerboost
The ' ' setting is a special setting (3200 W) for heating up a
large quantity of a liquid dish extra quickly. The powerboost
capacity is available for 5 minutes. After 5 minutes, the
cooking zone automatically switches down to boost. For the
next 5 minutes, the powerboost is not available. But after
that it is available again.
The display shows the setting selected. The lights blink if
there is no pan on the cooking zone. The selected cooking
zone switches off automatically after a short time.
You can see which setting to select in the cooking tables on
pages 22 and 23.
switching off
Press the on/off switch again.
The cooking zone switches off.
The residual-heat indicator will continue to indicate that the
zone is hot if it still is.
residual-heat indicator
The indicator shows that the cooking zone is still hot and
goes out as soon as the glass top reaches a safe
temperature. The indicator comes into operation after a zone
has been in use for 60 seconds and becomes visible after the
zone has been switched off.
residual-heat indicator
Residual heat is shown in the display with an H.
GB 12
' (boost), each cooking zone (except for the rear
timer
The appliance is fitted with a clock that can be used as a
cooking timer. This cooking timer is then independent and
has no effect on the settings of the cooking zones.
timer You can have a cooking zone switched off by the cooking
timer. The left cooking timer operates both left cooking zones
and the right cooking timer operates both right cooking
zones.
1 Switch to the cooking timer by pressing once on
the button.
2 Select the desired time (max. 3.59 hours) by pressing the
+ and – buttons. By keeping these buttons pressed
longer, the time will increase or decrease in larger and
larger steps.
The selected time is shown in the display.
3
When the selected time has expired, the hob starts
beeping. This beep can be switched off by pressing the
button.
timer function
1 Put a pan on a cooking zone.
2 Switch the cooking zone on.
The appliance starts to work.
3
Switch the cooking timer on with the
timer function Press the button
function again.
The lamp next to 'FRONT' (for the front zone) or 'REAR'
(for the rear zone) comes on. The cooking time is set
using the + and – buttons (max. 3.59 hours).
The number of minutes selected is shown in the display.
operation
switching on
button.
for the timer
GB 13