Replacing The Carbon Brushes; Environment; Eu Declaration Of Conformity - Festool IS 330 EB Notice D'utilisation D'origine

11.8 Lubrication and cleaning
We recommend cleaning the machine regularly.
Remove dust, cuttings, resin and other impuri-
ties. Detergents that contain solvents can harm
the painted surfaces or plastic parts. If you use
such detergents, we recommend that you fi rst
test their effect on a small hidden surface. Dur-
ing maintenance or replacement of any part of
the tool cutting set, clean the inside of the cover
by removing the accumulated dust and cuttings,
clean the guide groove, as well as the lubrication
and tension ports of the chain's guide bar. Do not
clean the rotary suction adaptor with your fi ngers!
The motor cover's ventilation ports must not be
blocked!

11.9 Replacing the carbon brushes

WARNING
The saw must undergo safety inspection to
maintain its protection category, and this work
must be done at an authorised facility licensed
to perform such work. Before servicing the tool,
always unplug the cord from the socket!
Have an authorised service facility handle re-
placement of the brushes, power cord, etc. If the
machine is dropped, it must be checked by an
authorised service centre to prevent any electrical
or mechanical hazard.
After approximately 200 operating hours, the
brushes must be checked. The brushes are ac-
cessible after removal of the hood. The brushes
must be replaced with new ones if they become
shorter than 5 mm.
The machine is equipped with self-detaching
brushes that come off automatically once the
minimum length is reached. Use only original-
equipment brushes!

12 Environment

Do not throw the power tool in your household
waste! Dispose of the machine, accessories and
packaging at an environmentally-responsible re-
cycling centre! Observe the valid national regula-
tions.
EU only: European Directive 2002/96/EC stipulate
that used electric power tools must be collected
separately and disposed of at an environmentally
responsible recycling centre.
Information on REACh:
www.festool.com/reach
30

13 EU Declaration of Conformity

Insulation saw
IS 330 EB
Year of CE mark: 2011
We declare under our sole responsibility that this
product is in conformity with the following stand-
ards or standardization documents:
EN 55 014-1, EN 55 014-2, EN 60 745-1, EN 60
745-2-13, EN 61 000-3-2, EN 61 000-3-3 accord-
ing to the provision of the regulations stipulated
in Directive 2006/42/EC, 2004/108/EC, 2000/14/
EC, 2011/65/EU.
Festool Group GmbH & Co. KG
Wertstr. 20, D-73240 Wendlingen, Germany
Dr. Martin Zimmer
Head of Research, Development and Technical
Documentation
20.03.2013
Serial no.
765700