Replacing The Air Filter; Change / Adjust Spark Plug; Changing The Engine Oil - Grizzly BRM 46-141 AT-OHV Traduction De La Notice D'utilisation Originale

as it could contaminate the fuel sys-
tem.
• To clean the blade housing, it is possi-
ble to connection a hose to the upper
side of the housing (32) (see
• After mowing, remove plant remains
that are stuck to the equipment by us-
ing a piece of wood or plastic. Clean
the vent holes, ejection hole and
blade area especially. Do not use hard
or pointed objects, which could dam-
age the equipment.
• Oil the wheels from time to time.
• Before each use, check the lawnmow-
er for obvious defects such as loose,
worn or damaged parts. Check that all
nuts bolts and screws are sitting firmly.

Replacing the Air Filter

Do not operate the equipment
without the air filter otherwise dust
and dirt will get into the engine and
result in damage to the machine
1. Release the screw at the air fil-
ter cover (14) and flip open the
cover
2. Remove air filter (13).
3. Replace a defective air filter
with a new filter (see "Spare
Parts").
4. To install, place new air filter (13)
into the air filter cover (14)
5. Close the air filter cover and lock
it into place

Change / adjust spark plug

A worn spark plug or a spark gap
that is too large will result in a re-
duction of engine performance.
1. Disconnect the spark plug con-
2. Unscrew spark plug (11a) coun-
).
3. Check the spark gap using a
4. If necessary, adjust the gap by
5. Clean the spark plug with a wire
6. Insert the cleaned and adjusted

Changing the Engine Oil

For oil change, tilt equipment back-
ward with handlebar. Do not place
equipment on side to prevent oper-
ating liquids from leaking.
• Change the engine oil for the
• Change the engine oil when the
• Dispose of the used oil in an
nector (11b) from the spark plug
by simultaneously pulling and
turning.
ter clockwise with spark plug
socket.
feeler gauge (available from
specialist shops). The spark gap
must be at least 0,75 mm.
carefully bending the ground
electrode on the spark plug.
brush.
spark plug or replace a dam-
aged spark plug with a new
one (Torch F6RTC; alternatively
Champion RN9Y or NGK BPR
6ES) (recommended torque
20 Nm, determined with a
torque wrench) (see "replace-
ment parts").
first time after around 5 operat-
ing hours then every 50 operat-
ing hours or annually.
engine is warm.
ecofriendly manner (see "dispos-
al / environmental protection").
GB
87