Cleaning And General Maintenance Work; Cleaning/Replacing The Air Filter - Grizzly BRM 46-125 BS Traduction De La Notice D'utilisation Originale

GB
Carry out maintenance and
cleaning work strictly with the
engine switched off and spark
plug connectors removed. Risk
of injury!
Allow the equipment to cool be-
fore any maintenance and clean-
ing work. Elements of the engine
are hot. Risk of burning!
Wear gloves when handling the
blade.
For cleaning and maintenance
work, also observe the Briggs &
Stratton instruction manual sup-
plied.
We recommend contacting an au-
thorised Briggs & Stratton dealer for
maintenance work on the engine.
You can find a dealer near you
here:
https://www.briggsandstratton.com/
na/en_us/support/dealer-locator.html.
Cleaning and General Mainte-
nance Work
Tilt the device back for cleaning
and maintenance jobs at the bot-
tom side so that the spark plug
faces upwards.
Make sure that a second person
holds the device because there is a
danger of tipping backwards.
Do not tilt the equipment sideways
or forwards. Operating fluids could
leak out and the engine could be
damaged.
94
• Always keep the equipment clean. To
clean, use a toothbrush or cloth but no
corrosive cleaning agents or solvents.
Do not use water to clean the engine as
it could contaminate the fuel system.
• After mowing, remove plant remains
that are stuck to the equipment by us-
ing a piece of wood or plastic. Clean
the vent holes (
and blade area especially. Do not use
hard or pointed objects, which could
damage the equipment.
• Oil the wheels from time to time.
• Before each use, check the lawnmower
for obvious defects such as loose, worn
or damaged parts. Check that all nuts
bolts and screws are sitting firmly.
• Check covers and guards (
2,11,14,22) for damage and that they
are sitting correctly. Replace if neces-
sary.

Cleaning/Replacing the Air Filter

Do not operate the equipment with-
out the air filter otherwise dust and
dirt will get into the engine and re-
sult in damage to the machine.
1. Remove the spark plugs connec-
tor ( 12) (see "Maintaining the
Spark Plug").
2. Open the air filter box (9) and
take out the air filter (10).
3. Clean the air filter (10) with soap
solution and let it dry. Put a few
drops of fresh engine oil into the
air filter.
4. To install, place the air filter (10)
in the air filter box (9) and reclose
it.
11), ejection hole