Initial Operation; Mount The Front Wheel; Installing The Handle Bar - Grizzly BRM 42-141 T-OHV Trike Mode D'emploi

Sound power level (L
measured ..................94 dB(A); K
guaranteed.......................................96 dB(A)
Vibration (a ) at handle
h
left ..............................4,9 m/s
right............................5,6 m/s
Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration
of conformity.
Technical and optical changes can be car-
ried out in the course of further develop-
ment without notice. All dimensions, refer-
ences and information of this instruction
manual are therefore without guarantee.
Legal claims, which are made on the ba-
sis of the instruction manual, cannot thus
be considered as valid.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Safety precautions aimed at pro-
tecting the user should be based
on estimated exposure under actu-
al usage conditions (all parts of the
operating cycle are to be consid-
ered, including, for example, times
during which the power tool is
turned off and times when the tool
is turned on but is running idle).
)
WA
=1.02 dB
WA
; K=1,5 m/s
2
; K=1,5 m/s
2

Initial Operation

Caution! Risk of injury from
rotating blades. Carry out work
on the equipment only when the
2
blade is switched off and sta-
2
tionary.
Before starting the equipment, you must
- Remove the Protective Caps
- mount the front wheel
- Install the handle bar
- if necessary,
mount the grass collection box
- Install the starter cord
- Fill with engine oil
- Fill with petrol
- Adjust cutting height if required

Mount the front wheel

1. Insert the two screws from the
inside through the recesses on
the front sheet steel housing
(14).
2. Fix the front wheel (11) with the
two washers and nuts.
3. Attach the front wheel (11) to
the top of the lawnmower hous-
ing (14) with the nuts and bolts.

Installing the Handle Bar

1. Slide the two ends of the lower
handle bar (3) into the receptor
on the mower housing.
2. Fix the lower bar using the sup-
plied wing screws (23).
D
3. Fasten the upper handle bar (1)
using the bar fastening screws
and locking levers (19).
GB
77