Exchanging The Cylinder; Cleaning, Maintenance, Storage; General Cleaning And Maintenance Work - Grizzly EV 1800-40 S Traduction De La Notice D'utilisation Originale

GB
move it to the side that has already
been treated.
• Guide the implement at a walking
pace down lanes that are as straight
as possible. To ensure uninterrupted
verticuting the individual lanes should
always overlap by a few centimetres.
Dwelling too long at the same place
while the implement is running can
damage the grass sward.
• To ensure that the extension cable
is not an impediment, turn the imple-
ment in such a manner that the cable
strain release on the bar always faces
the side that has been treated.
After work and to transport the im-
plement disconnect the power plug
and wait until the cylinder is stand-
ing still.
• Adjust the transport position setting
(see "Setting the Working Position")
when transporting the implement.
• Lift the implement to transport it over
steps and sensitive surfaces (e.g.
tiles).
• Always clean the implement after
each use (see "Cleaning, Mainte-
nance, Storage").
• After having treated lawns with dense
moss growth, it is advisable to reseed
the lawn so that it can regenerate it-
self quicker.

Exchanging the cylinder

Switch off the implement, discon-
nect the mains plug and wait until
the cylinder is standing still.
Wear gloves when handling the
cylinder.
68
1. Turn the implement over.
2. Release the fastening screw
(26) and fold the bearing cover
(27) away.
3. Remove the 3 screws (30) from
the equipment housing.
4. Tilt the cylinder upwards and
pull the shaft (28) and plastic
bearings (32) out.
5. Insert the new cylinder by re-
versing the sequence. Ensure
that the flattened side of the
bearing shell is first inserted in
the bearing.
Cleaning, maintenance,
storage
Work that has not been de-
scribed in these Instructions
must be carried out by a servic-
ing agency authorised by us.
Only use original parts.
Wear gloves when handling the
cylinder.
Prior to all maintenance and clean-
ing work always switch off the im-
plement, disconnect the plug from
the power socket and wait until the
cylinder is standing still.
General cleaning and
maintenance work
Do not jet water onto the imple-
ment and do not clean it under
flowing water. This would result
in the danger of an electric
shock and the implement could
be damaged.