Maintaining The Chain Bar; Storage; Technical Data - Grizzly EKS 1835-20 Traduction De La Notice D'utilisation Originale

Maintaining the chain bar

Use cut-protection gloves when
handling the chain or the chain
bar.
The blade must be inverted every 8-10
working hours in order to guarantee even
wear (see chapter "initial operation").
1. Switch off the saw and pull out the
power plug.
2. Remove the sprocket chain wheel
covering, the saw chain and the chain
bar.
3. Check the chain bar for wear. Remove
burrs and straighten the guide sur-
faces with a flat file.
4. Clean the oil passages of the
chain bar, in order to guarantee
a trouble-free, automatic oiling of
the saw chain during operation.
5. Mount chain bar, chainsaw and
sprocket chain wheel covering and
tighten the chainsaw.
With the oil nozzles in good condi-
tion and the oil regulator set cor-
rectly, the saw chain will spray a
little oil off after starting.

Storage

• Clean the equipment before putting it
away.
• Empty the oil tank before longer peri-
ods of non-use. Dispose of waste oil
environmentally correctly (see „Waste
disposal and environmental protec-
tion").
• Put on saw bar protection sheath.
• Store the appliance in a dry place well
out of reach of children.

Technical Data

Electrical chainsaw ............EKS 1835-20
Rated input voltage .............230 V~, 50 Hz
Input power ................................... 1800 W
Safety class .........................................
Protection type .................................... IP20
Chain speed ....................................14 m/s
Weight without guide rail
and chain ................................appr. 4.0 kg
Weight with guide rail
and chain ................................appr. 4.7 kg
Chain .............................Trilink JL9d-3*53
Chain bar ..........Trilink M1501453-1041TL
Chain link separation ..........3/8" (9.53 mm)
Chain width ................................. 1.27 mm
Teeth of the sprocket chain wheel ........... 7
Sawing length ......................max. 355 mm
Length of the chain bar ................. 420 mm
Sound pressure level
(L ) .................... 96 dB(A); K
pA
Sound power level (L
measured ........107 dB(A); K
guaranteed ............................ 112 dB(A)
Vibration a ... max. 6.76 m/s
h
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning:
The vibration emission value may
differ during actual use of the
power tool from the stated value
depending on the manner in which
the power tool is used.
Safety precautions aimed at pro-
tecting the user should be based
on estimated exposure under
GB
= 3.0 dB
pA
)
WA
= 3.0 dB
WA
; K = 1.5 m/s
2
103
II
2