Maintaining The Chain Bar; Waste Disposal And Environmental Protection; Spare Parts - Grizzly EKS 2440 QT Traduction De La Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 71
Never attach a new chain to a
worn drive pinion or place onto
a damaged or worn chain bar.
The chain could spring back or
break, potentially leading to se-
rious injury.

Maintaining the chain bar

Use cut-protection gloves when
handling the chain or the chain
bar.
The chain bar must be turned round every
10 working hours, in order to guarantee
uniform wear.
1. Switch off the saw and pull out the
power plug (18).
2. Remove the sprocket chain wheel
covering (15), the saw chain (5) and
the chain bar (4).
3. Check the chain bar (4) for wear. Re-
move burrs and straighten the guide
surfaces with a flat file.
4. Clean the oil passages (
the chain bar, in order to guarantee
a trouble-free, automatic oiling of the
saw chain during operation.
5. Mount chain bar (4), chainsaw (5) and
sprocket chain wheel covering (15)
and tighten the chainsaw.
Turning over the bar (4) requires you to
move the tensioning screw (
other side of the bar. Unscrew the retain-
ing bolt attaching the bar to the tensioning
screw. Move the tensioning screw over
to the other side of the bar and screw the
retaining bolt back in.
With the oil nozzles in good condi-
tion and the oil regulator set cor-
rectly, the saw chain will spray a
little oil off after starting.
Waste disposal and
environmental protection
Do not dispose of used oil in the sewage
system or drains. Dispose of used oil in
an environmentally correct manner - bring
it to a waste disposal center.
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Empty the oil tank carefully and hand in
your electric chainsaw at a disposal cent-
er. The plastic and metal parts employed
can be separated out and thus recycled
use can be implemented. Ask our Service-
Center for details.

Spare parts

25) of
The following spares are available from
J
Service-Center. Please indicate the ma-
chine type and the number of the spare
part with your order.
Saw chain ................................ 3009 1570
Chain bar ................................. 3010 0412
Bio chain oil 1 liter ................... 3023 0001
Bio chain oil 5 liter ................... 3023 0002
22) to the
F
If further spare parts should be necessary,
please find the part number on the explod-
ed drawings.
Machines do not belong with do-
mestic waste.
The Oregon replacement saw
chain is to be used only in con-
junction with the associated
Oregon blade and the electric
chainsaw approved for this.
There is a risk of injury.
GB
177

Publicité

Table des Matières
loading

Table des Matières