Patek Philippe GENEVE CALIBER CH 28-520 HU Manuel D'instructions page 15

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

15
chronograph
The chronograph is started and stopped by con-
secutively pressing the pusher at 2 o'clock. The
chronograph and minute-counter hands are reset
to zero with the pusher at 4 o'clock, either when
the chronograph is stopped or during an ongoing
measurement (flyback). If the pusher at 4 o'clock is
pressed while the chronograph and minute-coun-
ter hands are running, the two hands will instantly
jump to zero and start a new measurement right
away. This is referred to as the flyback function. If
the chronograph is first stopped with the pusher
at 2 o'clock, pressing the pusher at 4 o'clock will
return the chronograph and minute-counter hands
to zero. They will stay there until the next meas-
urement is started. To reset the chronograph hand,
make sure you press the pusher at 4 o'clock firmly
and squarely in the middle.
Note:
If the chronograph function is not needed, the chrono-
graph hand can continue to run just like an ordinary sweep
seconds hand. This will not cause premature wear of the
clutch mechanism or reduce the power reserve.

Publicité

Table des Matières
loading

Table des Matières