gefran SIEIDrive LIFT AGy-L Mode D'emploi page 236

LCD Display
P.501 Sw freq reduc en Enabling of switching frequency reduction
P.502 Min switch freq Minimum switching frequency
P.520 Overmod max lev Overmodulation level
P.540 Out Vlt auto adj Automatic adjustment of output voltage
P.560 Deadtime cmp lev Dead times compensation limit
P.561 Deadtime cmp slp Dead times compensation slope
P.580 Startup display IPA of the parameter to be displayed at power on
P.600 Speed dsply fact Speed conversion constant for display
P.998 Param access lev Access level
P.999 Param prot code Parameters protection code
A.000 PID mode PID mode
A.001 PID ref sel PID reference selector
236
PARAMETER
DESCRIPTION
PICK LIST
LCD Selection Description
[0] Disable
[1] Enable
As for P.500
0 Protection disabled Stopped motor: possibility to
write all parameters.
Running motor: some
parameters are writing protected
(IPA in bold)
1 Protection All parameters are writing
enabled protected excepted:
- F000, F100..F116, multispeed
function parameters
- P999 Param prot code
- C000 Save parameter (*)
(*) = only with - C020 Alarm clear
motor stopped - H500..H511, serial line
commands.
2 Protection All parameters are writing
enabled protected excepted:
- P999 Param prot code
- C000 Save parameter (*)
(*) = only with - C020 Alarm clear
motor stopped - H500..H511, serial line
commands.
3 Protection disabled Stopped motor: possibility to
write all parameters.
Running motor: some
parameters are writing protected
(IPA in bold)
Possibility to execute Save
parameter also with running
motor.
APPLICATION
[0] Disable Null
[1] Freq sum PID out in sum with ramp out ref
(Feed forward)
[2] Freq direct PID out not in sum with ramp out
ref (no Feed forward)
[3] Volt sum PID out in sum with voltage ref
from V/f curve (Feed forward)
[4] Volt direct PID out not in sum with voltage
ref from V/f curve (no Feed
forward)
[5] Stand alone PID function as generic control
(only with drive in RUN)
[6] St-Al always PID function as generic control
(any drive status)
[0] Null Null
[1] Analog inp 1 Analog input 1
0 0 1
(*) 0 P.500
0 0 100 % 1
1 0 1
(*) 0 255
(*) 0 255
8 1 1999
10.00 0.01 99.99 0.01
2 1 3
0 0 3
0 0 6
0 0 7
IPA
483
495
484
485
486
487
488
489
499
490
1200
1201
AGy -L