Safety Symbol Legend; Safety Precautions - gefran SIEIDrive LIFT AGy-L Mode D'emploi

Indicates a procedure, condition, or statement that, if not strictly observed, could result in personal injury or
death.
Warning
Indicates a procedure, condition, or statement that, if not strictly observed, could result in damage to or
destruction of equipment.
Caution
Indicates a procedure, condition, or statement that should be strictly followed in order to optimize these
applications.
Attention
Note!
Indicates an essential or important procedure, condition, or statement.
According to the EEC standards the AGy -L and accessories must be used only after checking that the
machine has been produced using those safety devices required by the 89/392/EEC set of rules, as far as
the machine industry is concerned. These standards do not apply in the Americas, but may need to be
Warning
considered in equipment being shipped to Europe.
drive systems cause mechanical motion. It is the responsibility of the user to insure that any such motion
does not result in an unsafe condition. Factory provided interlocks and operating limits should not be
bypassed or modified.
Electrical Shock and Burn Hazard:
When using instruments such as oscilloscopes to work on live equipment, the oscilloscope's chassis should
be grounded and a differential amplifier input should be used. Care should be used in the selection of probes
and leads and in the adjustment of the oscilloscope so that accurate readings may be made. See instrument
anufacturer's instruction book for proper operation and adjustments to the instrument.
Fire and Explosion Hazard:
Fires or explosions might result from mounting Drives in hazardous areas such as locations where
flammable or combustible vapors or dusts are present. Drives should be installed away from hazardous
areas, even if used with motors suitable for use in these locations.
Strain Hazard:
Improper lifting practices can cause serious or fatal injury. Lift only with adequate equipment and trained
personnel.
Drives and motors must be ground connected according to the NEC.
Replace all covers before applying power to the drive. Failure to do so may result in death or serious injury.
Adjustable frequency drives are electrical apparatus for use in industrial installations. Parts of the Drives are
energized during operation. The electrical installation and the opening of the device should therefore only be
carried out by qualified personnel. Improper installation of motors or Drives may therefore cause the failure
of the device as well as serious injury to persons or material damage. drive is not equipped with motor
overspeed protection logic other than that controlled by software. Follow the instructions given in this manual
and observe the local and national safety regulations applicable.
Always connect the drive to the protective ground (PE) via the marked connection terminals (PE2) and the
housing (PE1). AGy -L Drives and AC Input filters have ground discharge currents greater than 3.5 mA. EN
50178 specifies that with discharge currents greater than 3.5 mA the protective conductor ground connection
(PE1) must be fixed type and doubled for redundancy.
The drive may cause accidental motion in the event of a failure, even if it is disabled, unless it has been
disconnected from the AC input feeder.
Never open the device or covers while the AC Input power supply is switched on. Minimum time to wait
before working on the terminals or inside the device is listed in section 1.1.
48

Safety Symbol Legend

1 - Safety Precautions

AGy -L