MC Crypt Magic Ball Notice D'emploi page 22

Installation/Setup
Acceptance test (in case of industrial/public use):
Before first use and after any significant modifications, the installation (including the electrical
connections) must be checked by an official expert.
A yearly inspection by a technical expert is required.
At least every four years, a quality inspection must be carried out by an official expert.
• The light effect is attached to the assembly surface with the assembly bores in the casing. It can be installed
standing of handing.
• If you want to install the device with a suitable traverse system, attach the included mounting bracket to the casing
first.
• Then screw the light effect to the traverse system with the mounting bracket. Use only assembly material suitable
for the type of assembly and for bearing the effect light load.
• Make sure that the device cannot swing freely.
• Secure the installation with an additional suitable safety restraint cable or a safety net. The safety restraint cable
or the net must be designed to support the light effect in the event of a fault in the main support system.
• Make sure that the projector head of the light effect beamer can move freely; it may not hit onto anything or be
blocked.
22