DMX Connection
Setting up a Master Slave Chain
The effect light can be operated controlled by a DMX controller or in a master slave chain. In that case, the integrated
controller of the master device controls the connected slave devices.
•
Connect the DMX OUTPUT port of the master device to the DMX INPUT port of the first slave device.
•
Connect the DMX OUTPUT connection of the first slave device to the DMX INPUT connection of the second slave
device.
•
Proceed accordingly with all remaining slave devices.
•
Plug an XLR plug with a terminating resistor into the DMX OUTPUT connection of the last slave device (as
described in section "Connection of a DMX controller").
Mains Connection
The mains outlet to which the effect light is connected must be easily accessible to quickly
separate the device from the mains voltage in case of an error.
Do not let the mains cable come into contact with other cables.
Be careful when handling the mains cables and mains connection. Mains voltage can lead to
a fatal electric shock.
Make sure that no cables lie around openly. Install cables professionally to prevent accidents.
•
Connect the mains connector to the mains socket of the device.
•
Put the plug of the power line into a earthed wall socket.
•
The device is on as soon as it is connected to the power supply.
24