Connecting To A Wireless Network: Wi-Fi Protected Setup (Wps) - Martin Logan CADENCE Mode D'emploi

the Wi-Fi Status LED will start pulsing slowly. If
the soundbar is already configured to connect
to a Wi-Fi network, the LED will turn solid
(connected) or blink rapidly (not connected).
4. Once the Wi-Fi Status LED starts pulsing slowly,
your soundbar is in Access Point Mode and
ready to connect to your wireless network. Note:
If the soundbar's Wi-Fi Status LED is not pulsing
slowly, press and hold the W-Fi Setup button for
8 seconds until you have heard two tones—one
at 3 seconds and another at 8 seconds. You
can also choose "Wireless Setup > From Play-Fi
App" from the soundbar menu to enter Access
Point Mode. After 20 seconds, the Wi-Fi Status
LED will begin pulsing slowly to indicate Access
Point mode is ready. At anytime you can press
the button again to cancel the setup mode.
5. Launch the DTS Play-Fi
Android Device Users:
a) The app will automatically find your device
and provide prompts for setup.
b) Touch the "Setup" button on the screen.
c) Enter the password for your wireless network;
the app will connect your device to your
network.
d) Once your device is connected, you will
notice that the Wi-Fi Status LED on your
soundbar will change from blinking to solid.
This may take up to a minute. If, after a
minute, the button continues to blink rapidly,
setup failed and you should try again.
iOS Device Users:
Please note: When using an iOS device your
soundbar can stream audio using either Apple
AirPlay or DTS Play-Fi.
a) Make sure your iOS device's Wi-Fi is turned
on and connected to your Wi-Fi network.
b) Open your iOS device's 'Settings' app and
go to the 'Wi-Fi' menu. Your soundbar will
32
app.
®
show up under the heading '
...'
airplay speaker
c) Select your soundbar from the list. It will
have "Play-Fi " in the name.
d) Once in the 'AirPlay Setup' menu you will
be prompted to select your Wi-Fi network
and name your soundbar (you will not need
to enter your network password).
e) Once your soundbar is connected, you will
notice that the Wi-Fi Status LED on your will
change from blinking to solid. This may take
up to a minute. If, after a minute, the LED
continues to blink rapidly, setup failed and
you should try again.
f) Your soundbar is now connected to your
wireless network. Reconnect your iOS device
to your wireless network.
PC Users:
a) The app will automatically find your device and
provide prompts for set up. If the app does not
prompt you to set up a new device, within the
app go to the settings screen and click 'Setup
Play-Fi Device'. Follow the on-screen instructions.
b) Click the "Set-up" button on the screen.
c) Select the speaker(s) you want to set up.
d) Enter the password for your wireless network;
the app will connect your device to your
network. You will notice the Wi-Fi Status LED
will have changed from blinking to solid. This
may take up to a minute. If, after a minute, the
button continues to blink rapidly, setup failed
and you should try again.
6 Your soundbar is now connected to your wireless
network. Reconnect your mobile device or PC
to your wireless network. You may re-name your
device using the app.
CONNECTING TO A WIRELESS NETWORK:
Wi-Fi PROTECTED SETUP (WPS)
Wi-Fi Protected Setup (WPS) is a feature found on most
set up new