Wired Subwoofer Connection; Wireless Subwoofer Connection; Ir Outputs - Martin Logan CADENCE Mode D'emploi

Wired Subwoofer Connection

Using a high-quality RCA style cable designed for
subwoofer connection, connect "Sub Out" from the
soundbar to the "LFE In/Sub In" on the subwoofer.
Use the soundbar's menu system and choose
'Subwoofer > Wired Sub'.
Reference your subwoofer's manual to learn how to
properly adjust the sub's level and phase controls
to achieve proper blending with the soundbar. The
subwoofer's crossover should be set to "bypass",
"LFE". For subwoofers that do not have a "bypass"
or "LFE" crossover setting, we recommend adjusting
the crossover to its highest setting.

Wireless Subwoofer Connection

Use the soundbar's menu system and choose
'Subwoofer > Wireless Sub > Sync Subwoofer'.
The soundbar will display 'Push and Hold Button'.
Press and hold the subwoofer wireless receiver's
sync button. Connection is successful when the sta-
tus light turns solid and the soundbar responds with
'Synced'.
Please note: If a link is not established the wireless
receiver's LED will blink slowly and the soundbar will
display 'Failed'. Power the soundbar on and off,
unplug the wireless receiver and plug it back in, and
repeat syncing.
Reference your subwoofer's manual to learn how to
properly adjust the sub's level and phase controls.
The subwoofer's crossover should be set to "bypass"
or "LFE". For subwoofers that do not have a "bypass"
or "LFE" crossover setting, we recommend adjusting
the crossover to its highest setting.
Please note: The subwoofer wireless transmitter
built in to this soundbar is not compatible with
MartinLogan's SWT-1 or SWT-2 subwoofer wire-
14
less technology. If your subwoofer has SWT-1 or
SWT-2 technology built in you can still utilize the
soundbar's wireless functionality by connecting
the wireless subwoofer receiver to the LFE input
on your subwoofer, or connecting an SWT-1 or
SWT-2 transmitter to the Sub Out on the soundbar.
Please note: If you decide to no longer use wire-
less, turn off the soundbar's wireless transmitter by
using the menu system and choosing 'Subwoofer
> Wireless Subwoofer > Turn Wireless Sub Off'
or 'Subwoofer > No Sub'. Doing this will turn off
the transmitter and automatically set the soundbar
for no sub.
WARNING! When operating wirelessly, the
subwoofer may be susceptible to RF interference
in the 2.4GHz bandwidth from microwave ovens
and wireless devices such as Wi-Fi systems, video
game consoles, cordless telephones, Bluetooth
devices, and baby monitors. Generally, this issue
(intermittent sound or slight popping noises) is eas-
ily resolved by physically separating problematic
devices from one another—a distance as little as
two feet will often alleviate the interference. In the
case of microwave ovens, the interference will only
occur when the microwave is operating.

IR OUTPUTS

These jacks accept IR emmiters with 3.5mm mono-
style connectors. One IR emmiter is included with
the soundbar.
Plug the IR emitter into either of the soundbar's IR
Out jacks and place the other end of the IR emitter
over the IR sensor on another piece of equipment
The use of an IR emitter allows the soundbar to
pass IR signals from any remote control to a teth-
ered device—allowing control of equipment in
locations a remote would normally not reach.