Martin Logan CADENCE Mode D'emploi page 29

• Input: HDMI 2
• Input: HDMI 3
• Input: HDMI ARC
• Input: Bluetooth
• Input: Optical 1
• Input: Optical 2
• Input: Analog 1
• Input: Analog 2
• ARC On [Anthem Room Correction On]
• ARC Off [Anthem Room Correction Off]
Choose the command you want to program and press
the enter button. The soundbar will respond with 'Push
Button'. Hold the second remote approximately 12
inches (30cm) from the soundbar and press the appropri-
ate button four times. If the new command is learned
successfully, the soundbar's display will display "Saved".
If the new command is not learned, the soundbar will
display "Failed". Repeat the process if learning fails.
Learn Remote > Reset Remote: Enter the
submenu by pressing the enter button. Resetting
will clear programming for the second remote. The
Reset function requires confirmation.
Learn Remote > Reset Remote > No: Activate
by pressing the enter button. Choosing this option will
exit without erasing the remote programming.
Learn Remote > Reset Remote >Yes:
Activate by pressing the enter button. The soundbar
will respond with 'Resetting'. After codes are reset,
there is no way to recover the previous settings.
MENU OPTION: SOURCE NAME
Source Name: Enter the submenu by pressing
the enter button. The settings in this menu will allow
you to assign new names to display on the sound-
bar when changing inputs. For example, you can
program the 'Optical 1' input to display 'DVD'.
Using the up/down directional buttons, you can
select and program the following input names:
• HDMI 1
• HDMI 2
• HDMI 3
• HDMI ARC
Choose the input name you want to reprogram and
press the enter button. The soundbar display will
display the current name. Pressing the up/down
directional buttons will cycle through the available
alpha-numeric characters. Pressing the left/right direc-
tional buttons will move to the next/previous space.
To finish programming an input name, use the left/
right buttons to move all the way to the left or right.
MENU OPTION: SERVICE
Service: Enter the submenu by pressing the enter
button.
Service > Firmware: Enter this submenu by
pressing the enter button.
Service > Firmware > MCU: Pressing the
enter button will display the current firmware ver-
sion for the soundbar MCU (microcontroller unit).
Service > Firmware > DSP: Pressing the
enter button will display the current firmware ver-
sion for the soundbar's DSP module.
Service > Firmware > IA3S4: Pressing the
enter button will display the current firmware version
for the soundbar's Wireless subwoofer module.
Service > Firmware > TC390: Pressing the
enter button will display the current firmware ver-
sion for the soundbar's Tact button module.
Service > Firmware > MAC MCU: Pressing
the enter button will display the current firmware ver-
• Optical 1
• Optical 2
• Analog 1
• Analog 2
29