Changing The Remote's Battery; Programming A Second Remote - Martin Logan CADENCE Mode D'emploi

CHANGING THE REMOTE'S BATTERY

The remote control for your speaker uses two AAA
type batteries. Access the battery compartment by
using a Phillips screwdriver to remove the screw lo-
cated on the bottom of the remote.
Caution! Danger of explosion if bat-
tery is incorrectly replaced. Replace
only with the same or equivalent type.

PROGRAMMING A SECOND REMOTE

This soundbar can be programmed to respond to a
second remote. See "The Menu System" section of
this manual for programming instructions.
Please note: There may be remote controls that the
soundbar cannot learn or that the soundbar can
not learn correctly. Due to the number of available
remote controls, it is impossible to advise which
will or will not work.
Please note: When learning from a second remote,
you will likely find it does not have buttons that directly
correspond with all available soundbar commands.
Not all soundbar commands have to be programmed.
Some remote controls offer 'function' buttons (F1, F2,
etc.) that can be used to program unique soundbar
commands such as 'NITE.MD' or 'OPTIC'.
Please note: Some remote controls offer discrete
'power on' and 'power off' buttons. Some offer
only a single button to toggle power on and off.
The learning function of the soundbar allows you to
program for either scenario.
Fig. 9
19