Wireless Setup; Learn Remote - Martin Logan Verse Manuel De L'utilisateur

directional buttons, choose the desired volume
level. Once set the soundbar will always be set
to this level when it powers on or comes out of
standby. The default level is –35dB.
Power Settings > Power-On Volume >
Last Used: When Power Standby is set to "Last
Used", the soundbar will power on or come out of
standby at a volume level matching the volume set-
ting when it was powered off or went into standby.
Power Settings > IP Control: Enter the sub-
menu by pressing the enter button. Here you can turn
IP Control off or on. IP Control allows the soundbar
to respond to incoming IP commands from networked
home control systems connected via Ethernet.
Power Settings > IP Control > Off or
On: This option turns the IP Control feature off or
on. Activate by pressing the enter button and the
soundbar will respond with 'Saved'.
Power Settings > Standby IP: Enter the sub-
menu by pressing the enter button. Here you can turn
Standby IP off or on. This allows you to configure
how the soundbar responds to incoming IP com-
mands when it is in standby mode.
Power Settings > Standby IP > Off or On:
This option turns the Standby IP feature off or on.
Activate by pressing the enter button and the sound-
bar will respond with 'Saved'. When this setting is
set to "Off" the soundbar will not respond to incom-
ing IP command when it is powered off or in standby
mode. If IP Control set to Off, Standby IP is disabled.
MENU OPTION: WIRELESS SETUP
Wireless Setup: Enter the submenu by pressing
the enter button.
Wireless Setup > Bluetooth Pairing:
Activate by pressing the enter button. The soundbar
26
will respond with 'Pairing Mode On'. The sound-
bar will remain in pairing mode for 5 minutes. Use
your source device's Bluetooth setup menu to setup
a Bluetooth connection.
MENU OPTION: LEARN REMOTE
Please note: There may be remotes that the soundbar
cannot learn or that the soundbar can not learn cor-
rectly. Due to the number of available remotes, it is
impossible to advise which remotes will or will not work.
Please note: When learning from a second remote,
you will likely find it does not have buttons that directly
correspond with all available soundbar commands.
Not all commands have to be programmed. Some
remotes offer 'function' buttons (F1, F2, etc.) that can
be used to program unique soundbar commands such
as 'Bass Mode: Night' or 'Input: Optical 1'.
Please note: Some remote controls offer discrete
'power on' and 'power off' buttons. Some offer
a single button to toggle power on and off. The
learning function of the soundbar allows you to
program either scenario.
Learn Remote: Enter the submenu by pressing
the enter button. The settings in this menu program
the soundbar to respond to a second remote con-
trol. The factory supplied remote control will always
work with the soundbar, even if the soundbar is pro-
grammed to respond to a second remote.
If you attempt to program a remote code from a
second that is already programmed the soundbar
will respond with "Failed".
Using the up/down directional buttons, you can
select and program the following commands:
• Volume +
• Volume –
• Mute