Manually Changing Feed Plate Angle - Miller RAD-400 Manuel D'utilisation

2-9. Manually Changing Feed Plate Angle

OM-1598 Page 14
15°
Max.
Turn knob
counterclockwise
1 Feed Plate Screw
Loosen screw.
2 Hub Clamp Screw
Tighten screw.
3 Adjusting Knob
Turn adjusting knob to change torch
angle.
.
The feed plate maximum tilt
1
angle is about 15 degrees from
center in both directions.
2
3
15°
Max.
Turn knob
clockwise
Tools Needed:
1/4 in
802 594-B / ST-802 598