Location Of Torch For Tandem Arc Applications - Miller RAD-400 Manuel D'utilisation

2-10. Location Of Torch For Tandem Arc Applications

3
Torch Right Of Center
1 Feed Plate
The feed plate can be set up with the torch
in two different locations for tandem arc ap-
plications.
To change the torch to right of center:
2 Hub Clamp Screw
Loosen hub clamp screw.
3 Manipulator Screw
Remove manipulator screw.
4 Insert Screws
Remove insert screws.
5 Insert Block
Remove insert block
.
Follow instructions below to change torch to right of center or left of center.
1
8
6
5
4
6 Hub Clamp Assembly
Turn hub clamp assembly 180 degrees.
Reassemble in reverse order of disassem-
bly.
.
Re-tighten hardware when the assem-
bly is in the desired position.
To change the torch to left of center:
7 Feed Plate Screw
Loosen feed plate screw.
Remove manipulator screw.
Remove insert screws.
Remove insert block
Turn feed plate 180 degrees.
Assembly As Shipped
7
Tools Needed:
1/4, 3/16 in
2
Torch Left Of Center
802 594-B / ST-802 599
Reassemble in reverse order of disassem-
bly.
8 Inlet Guide
Remove inlet guide and install in correct
position.
NOTE: For torch to left of center applica-
tions, the leads in the power cord plug must
be reversed to reverse direction of motor
shaft as follows:
White lead to pin 1
Black lead to pin 3
Green lead to pin 5.
.
Re-tighten hardware when the assem-
bly is in the desired position.
OM-1598 Page 15
3/8 in